What is Cable Select? - Computer Hope
WEBSep 12, 2023 · Cable select, also referred to by the acronym CS, is a disk drive jumper setting which automatically sets the priority of a disk drive by its position on its data cable. When cable select is enabled, the drive configures itself as a primary or secondary depending on its position in the drive chain. For cable select to work, an IDE (Integrated ...
Master/Slave Settings vs. Cable Select - PC Hell
WEBUnder normal circumstances, the end of the drive cable attaches to the Master hard drive, while the inside connector on the cable connects to the Slave drive. What About Cable Select? Cable Select (CS) settings were designed to make it easier to connect hard drives because you didn't need to bother with setting the Master/Slave jumpers.
Using IDE Cable Select - Unixwiz.net
WEBSep 10, 2002 · All IDE drives have jumpers that select the "master" or "slave" role on the controller, but modern drives also have a "CS" or "Cable select" pin. This allows the IDE cable itself to select the drive's role: all the drives have the CS jumper set, and the cable chooses the master and the slave.
Master, Slave and Cable Select Hard Drive Jumper Settings
WEBOct 24, 2012 · Cable Select (CS) settings were designed to make it easier to connect hard drives by making it where you didn’t have worry about the Master or Slave jumper settings. You simply set the jumper to Cable Select on both drives and depending on where you connected them to the cable the computer would know which is Master and which is Slave.
cable select vs master/slave - Dell
WEBNov 21, 2004 · Cable select determines the master/slave by which connection the drive is connected on via the IDE cable. The drive on the end of the cable is MASTER, the one on the middle connector is the SLAVE. So you deterime which is MA/SL by where it is connected on the cable.
What is Cable Select (CSEL)? - CdrInfo.com
WEBCable Select (CSEL) is an optional feature according to the ANSI ATA specification. It is an alternative method of identifying the difference between device 0 and device 1 on an IDE interface cable.
Using Cable Select - O'Reilly Media
WEBUsing Cable Select. All recent ATA/ATAPI drives provide a Cable Select (CS or CSEL) jumper in addition to the standard Master/Slave jumpers. If you jumper a drive as Master (or Slave), that drive functions as Master (or Slave) regardless of which connector it is attached to on the ATA cable.
cable select questions - Dell
WEBJan 30, 2005 · The goal of cable select is to eliminate having to set master and slave jumpers, allowing simpler configuration. To use cable select, both devices on the channel are set to the "cable select" (CS) setting, usually …
When was "Cable Select" introduced for IDE devices?
WEBSep 7, 2019 · Cable Select (CS) appeared as an optional component of ANSI standard X3.221-1994 in 1994, the first published standard describing “IDE” (and later known as ATA-1).
Cable Select vs Master/Slave, which do you use?
WEBDec 3, 1999 · With cable select, it is the way the wires are connected that makes the difference (I guess), so only one drive gets the signal that it should respond to commands, dependending on which...